Hardware Support

DYNAMIXEL DYNAMIXEL is a robot exclusive actuator developed by ROBOTIS, and the name derived from two words. DYNAMIC + CELL = DYNAMIXEL Any content is good. Let’s talk and share about DYNAMIXEL together.

Topic	Replies	Views	Activity
About the Hardware Support category Hardware Support	0	45	October 27, 2022
Control of servo motors for position and constant angular velocity DYNAMIXEL dynamixel	0	107	September 7, 2022
Darwin OP computer not turning on Hardware Support robotics	0	672	April 11, 2019
New LDS for TB3 Hardware Support	2	290	May 9, 2022
Dynamixel controller opportunity and failed communication (MoveIt) DYNAMIXEL ros	0	133	May 4, 2022
How can I reset CM - 530? Hardware Support robotics	3	180	February 11, 2022
Openmanipulator Tutorial from emanual gives "exit code 127" DYNAMIXEL	1	144	January 14, 2022
Dynamixel and Arduino DYNAMIXEL	11	1697	November 3, 2021
How to use data realtime in servo(goal position) DYNAMIXEL robotics , dynamixel	14	388	July 15, 2021
RE: AX-12A, Dynamixel Protocol_1, and U2D2 DYNAMIXEL	6	782	July 15, 2021
Time out pop up in Dynamixel Wizard DYNAMIXEL robotics , dynamixel	6	1058	May 28, 2021
How to get feedback sensor on XL430 motor DYNAMIXEL robotics , dynamixel , manipulation	1	437	May 28, 2021
Control of Dynamixel XM430-W210 with very low latency (< 1ms). Is that possible? DYNAMIXEL dynamixel	1	309	May 6, 2021
Dynamixel XC430-W150 DYNAMIXEL	3	356	April 8, 2021
Regarding the MX-12W servo motor from the Dynamixel Family DYNAMIXEL	5	342	March 9, 2021
Unbrick an OpenCM 09.04 C Hardware Support	1	403	March 4, 2021
Raspberry Pi and AX-12A - No Response DYNAMIXEL	11	1016	March 2, 2021
Struggling to use MX-28AR with Arduino DYNAMIXEL	2	671	February 22, 2021
How to set up velocity profile for dynamixel motor DYNAMIXEL	9	3907	January 4, 2021
AX-12A on U2D2 does not work DYNAMIXEL	4	1775	December 7, 2020
Program (source code) example for dynamixel SDK, U2D2, and AX-12A? DYNAMIXEL	1	510	December 3, 2020
OpenCR 1.0 usb not recognized Hardware Support	1	508	December 3, 2020
Set toque limit servo - OpenCM 9.04 with 485 Exp DYNAMIXEL	1	500	December 3, 2020
RE: Half Duplex UART for TTL Commincation and Wiring w/ the HC126 and HC04 DYNAMIXEL robotics , project	59	4174	November 9, 2020
Electrical properties of AX-12A interface DYNAMIXEL	6	741	November 3, 2020
MX64AR servo RED LED keeps blinking DYNAMIXEL	1	302	November 3, 2020
RE: Opposing Threaded Hole Away from the Wheel on the Servo/ID DYNAMIXEL dynamixel	0	337	October 21, 2020
Synchronisation loop with velocity and acceleration profile DYNAMIXEL	3	519	October 14, 2020
Motor having trouble moving C++ DYNAMIXEL	1	372	October 5, 2020
Jetson Nano + OpenCR + Dynamixel Motor DYNAMIXEL ros	7	2298	September 25, 2020